* Remove the inner door panel
    * lower the window until you can see the stop-screw head attached to the regulator. Loosen it and drop it to it's lowest adjustment point (get it out of the way)
    * Lower the window until the TOP is even with the felt cat-wiskers of your door.
    * loosen the FRONT track's lower phillips head star-washered screws. Making sure the window is bottomed in the rear window channel- pull the FRONT channel TIGHT against the triangular guide on the window-track. tighten the BOTTOM screws.
    * Roll the window UP until it is completely closed and bottomed in the TOP and REAR window channel
    * Loosen the UPPER 2 screws for the FRONT window run. Pull the run rearward until it is snug against the triangular guide on the window-track. Tighten the screws
    * Lower the window until it is even with the cat-wiskers and slide the window-stop against the regulator arm- tighten the screw. 



Ray Ficthorn
Ray-Lin Restorations
Winston-Salem, NC