The Largest (over 4GB) Studebaker Information Portal on the Internet

Anti Creep Brake system

Factory Installation Plate

Operation Schematic

On letting off gas pedal, paddle switch on throttle linkage closes and grounds circuit. Rear transmission pump is driven by rear wheels. Solenoid switch is tapped into rear pump. When car comes to a halt, pressure drops, actuating transmission switch and closing circuit to solenoid. One way valve in solenoid locks brakes on.

When gas pedal pressed to accelerate, paddle switch on throttle linkage opens and breaks ground, opening brake line solenoid, releasing brakes. System can be used on rear wheels ONLY or ALL four. Never only on front

Transmission switch

Brake line Solenoid