Studebaker Drivers Club, Inc.
Studebaker Drivers Club, Inc.
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 Your Studebaker Forum
 Technical Talk
 Kent -Moore pilot studs
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

Kdancy
Commander Member

1029 Posts

Posted - 03/22/2010 :  4:08:55 PM  Show Profile  Reply with Quote
Looking for the two Kent-Moore pilot studs J 4284 for the early stude DG automatic. If some one that has them can just give me the measurements, I'll make a copy. These were part of the Kent-Moore DG essential service tool kit.

r1lark
Commander Member

USA
1063 Posts

Posted - 03/22/2010 :  7:31:59 PM  Show Profile  Reply with Quote
quote:
Originally posted by Kdancy

Looking for the two Kent-Moore pilot studs J 4284 for the early stude DG automatic. If some one that has them can just give me the measurements, I'll make a copy. These were part of the Kent-Moore DG essential service tool kit.



Kdancy,

The early DG and the later Flightomatic use the same J-4284 pilot studs. You can make these be taking a Grade 5 capscrew, 7/16"-14 thread, cutting the head off, tapering the end, and cutting a slot in the end with a hacksaw. Dimensions are: overall length = 2-3/8"; thread length = 1-1/8"; tapered section length = 1/2"; tapers down to 1/4" at the end.

Pics are below. I couldn't resist taking an extra picture of the Kent-Moore bag, it is pretty cool!



Paul
Winston-Salem, NC
Visit The NEW Studebaker Skytop Registry website at: www.studebakerskytop.com
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
Studebaker Drivers Club, Inc. 2003-2010 Studebaker Drivers Club, Inc. The SDC logo is a registered trademark. All rights reserved Go To Top Of Page
This page was generated in 0.2 seconds. Powered By: Snitz Forums 2000 Version 3.4.07